chip tuning installation

The installation of Windbooster is simple and easy to understand

Below are a few steps of installation

  1. Turn off the engine and wait for 10 minutes before you install the device
  2. Remove the original sensor plug from the accelerator pedal, then insert the adapter into accelerator pedal outlet, and connect the original sensor plug to the adapter, or you can connect the original sensor plug to the adapter, then insert the adapter into the accelerator pedal outlet(these two situations depends on the car model)
  3. Next, attach the display screen anywhere on the dashboard
  4. Then connect the display with adapter cable
  5. Finally, fix the cable with cable ties

The above are pretty typical installation steps applying to most vehicles. In some vehicles the installation may vary.